ODI DFP-34X-2C2 very slow under load #359
Replies: 8 comments 1 reply
-
try this to enable/add DSCP QoS:
|
Beta Was this translation helpful? Give feedback.
-
thanks but same result :( after running both commands:
|
Beta Was this translation helpful? Give feedback.
-
@Anime4000 my bad, IPv6 was routing via the other ISP, will try again later |
Beta Was this translation helpful? Give feedback.
-
Hello guys. Need some help confirming if ODI DFP-34X-2C2 supports VEIP. I am from Argentina (Personal ISP) and need to replace a Huawei HG8245U ONT served by ALCA OLT. I tried a GPON-ONU-34-20BI but was not able to get it working. People here have successfully replaced the HG8245U with Ubifiber Loco so I am confident there should be a GPON stick that can work. Thanks! |
Beta Was this translation helpful? Give feedback.
-
stick GPON-ONU-34-20BI, have you patched for Software Version to work? |
Beta Was this translation helpful? Give feedback.
-
Yes, patched SW version, still seems stick cannot figure out what to do with the VLANs. ME171 is empty. I attached the OMCI log in case you want to take a look. |
Beta Was this translation helpful? Give feedback.
-
hey @Anime4000 sorry for the delay, same thing happens on IPv6, any other ideas? |
Beta Was this translation helpful? Give feedback.
-
hey @Anime4000 I've managed to get it working correctly with a HGU ( |
Beta Was this translation helpful? Give feedback.
-
Hi
I've managed to get O5 and IP via DHCP (as expected) from my ISP but I have high ping when trying to download and specially upload
Original ONT: Technicolor TCG2232 (this is a custom model for my ISP AFAIK, original model is FGA2232CLB)
My plan: 500Mbps / 250Mbps
OLT: Huawei
I've tried a bunch of firmware versions and options, all with the same result...
ODI DFP-34X-2C2
Firmwares:
There are 5 vlans, the one used for internet is vlan
11
(the one I'm using) with the defaultFwdOp
of0x10
, I've tried0x02
but got same resultsOMCC_VER
:0x80
through0xA3
works (with slow speed),0xB0
through0xB3
does not work, currently using0x80
OMCI_OLT_MODE
: all of them works (with slow speed), currently using1
OMCI_TM_OPT
:0
and2
works (with slow speed),1
does not work, currently using2
I'am not trying to use the 2.5Gbps interface, it is connected to a Unifi Deam Machine Pro. I have another ODI stick with another ISP on the same UDMP and it is working fine.
I have obviously tested everything with the original ONT (Technicolor) and it works as expected, any help is GREATLY appreciated, please let me know if you need more info or want to test something
I have a good ping when the connection is idle (no download/upload):
But when I start a download I don't get the full speed, only around half (~20MB/s) and ping increases 100x:
I don't have an ease way to test the upload so I run a
speedtest
:omcicli mib get 131
omcicli mib get 84
omcicli mib get 171
omcicli mib get 329
omcicli mib get 280
omcicli mib get 11
diag gpon show us-flow
diag gpon show ds-flow
Beta Was this translation helpful? Give feedback.
All reactions