Conflict with Path Source Trigger Character ‘/’ in Frontend Development

[emnnipal]

Make sure you have done the following

• Updated to the latest version of blink.cmp
• Searched for existing issues and documentation (try <C-k> on https://cmp.saghen.dev!)

Bug Description

My issue is that the path source sometimes isn’t helpful, especially in frontend development. The trigger character for path source is /. This causes a problem when working with path routes in frontend development since those start with /.

In the attached video, when I type /, the route /post/postId is no longer available in the cmp results unless I type /p instead. This behavior makes it harder to quickly navigate through frontend paths since path sources are also showing up.

Additionally, in the video, I tried to add a new route type, /test, and as you can see, the path sources are showing up, which is unnecessary since I’m defining a type in the route type. This may not be an issue, but it would be a good scenario where path sources should not show, if that’s possible.

Screen.Recording.2025-01-06.at.2.40.49.AM.mov

Relevant configuration

No response

neovim version

NVIM v0.10.3

blink.cmp version

v0.9.2

[Saghen]

Converting this to a discussion since the path source is working as expected but it may be helpful for others to disable it for this case