Prusa or Orca Slicer Start G Code Example

[Rneil-ca]

Hi ,

Sorry for another new discussion, but I am so close to get this all working. Thank you again for building this, it is great. Do you have an example of what should be in PrusiaSlicer or Orcaslicer start G-code? I though I found an example somewhere when I was digging through the config examples and issues, but I look everywhere again and could not find this.

Thanks again,
Ryan

[TypQxQ]

Don't know why it disapeared but I added it again:
config/PrusaSlicer_Custom_Gcode.md

[Rneil-ca]

Thank you, that is what I was looking for!