Skip to content

Latest commit

 

History

History
74 lines (45 loc) · 2.29 KB

README.MD

File metadata and controls

74 lines (45 loc) · 2.29 KB

News

  • The firmware supports any one in the list below. The firmware used in the list below is the same and there is no need to distinguish it.
  • debug.bin outputs all debug messages from USBCDC
  • release.bin outputs all debug information from Qwiic UART

1️⃣Support Product

Product(PinMap) Release Debug
T-Display-AMOLED-Lite firmware firmware
T-Display-S3 AMOLED firmware firmware
T4-S3 firmware firmware

2️⃣How to Flash ?

Use ESP Download Tool

web_flasher

  • Note that after writing is completed, you need to press RST to reset.

Use Web Flasher

web_flasher

  • Note that after writing is completed, you need to press RST to reset.

Use command line

If system asks about install Developer Tools, do it.

python3 -m pip install --upgrade pip
python3 -m pip install esptool

In order to launch esptool.py, exec directly with this:

python3 -m esptool

For ESP32-S3 use the following command to write

esptool --chip esp32s3  --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m 0x0 firmware.bin

2️⃣FAQ

  • Can't upload any sketch，Please enter the upload mode manually.
    1. Connect the board via the USB cable
    2. Press and hold the BOOT button , While still pressing the BOOT button (If there is no BOOT button, you need to use wires to connect GND and IO0 together.)
    3. Press RST button
    4. Release the RST button
    5. Release the BOOT button (If there is no BOOT button, disconnect IO0 from GND.)
    6. Upload sketch
    7. Press the RST button to exit download mode