Text capacity with Fast Koko?

[RBEmerson970]

Using Fast Koko to read back a short story, I found it seems to max out at about 15 minutes of text. After that I get fragments of the text.

What's the upper bound on what Fast Koko will accept?

[remsky]

I've run it on a few hours worth without issue, and listened through. What route are you using? Through the WebUI, or API?

[RBEmerson970]

I'm using the web access.

Updated to 0.2.2 and the problem persists I've attached the full log, from installation to starting to speak, along with a grab of the UI.. Note the play time is given as 13:55 which is much too short fo 50k characters. At somewhere around 13:15-:20 the playback skips through the remaining text, reading some chunks, but skipping others.

The text, in PDF form, can be collected here: https://drive.google.com/file/d/1j8ktSuWqgm8w3tWPB1csP8Dvf_qmHAM-/view?usp=drive_link
When using Fast Koko I do CTRL-A, CTRL-C, paste into the Fast Koko text window. I don't use formatting (which compresses the text into a block (makes problems when following in the manuscript).

Install+Run.txt

[RBEmerson970]

BUMP. Any progress?

[remsky]

Sent a request to access the text, will check it out

[remsky]

I'll add in a fix for the 'format' compressing it to block as well.

[RBEmerson970]

[/2 thumbs up]
Link sent.

[RBEmerson970]

BUMP
I'm still hitting a point where the speech goes from linear "word for word" to the beginning of subsequent chunks. This happens +/- 13 minutes into a text.
In my particular case, I read text that I'm writing for a novel, and listening for tense errors, missing or duplicated words, etc.. Using small clips to wade through 50K+ words... not a winner.