🌟LilyGO Mini Epaper🌟

---

1️⃣Product

Product(PinMap)	SOC	Flash	PSRAM	Resolution	Size	Driver
Mini-E-Paper-ESP32 PICO	ESP32-PICO	4MB	x	128x80	1.02 Inch	GDGDEW0102T4
Mini-E-Paper-S3	ESP32-FN4R2	4MB	2MB(QSPI)	128x80	1.02 Inch	GDGDEW0102T4

Quick start ⚡:

2️⃣ PlatformIO Quick Start (Recommended)

1. Install Visual Studio Code and Python
2. Search for the PlatformIO plugin in the VisualStudioCode extension and install it.
3. After the installation is complete, you need to restart VisualStudioCode
4. After restarting VisualStudioCode, select File in the upper left corner of VisualStudioCode -> Open Folder -> select the LilyGO-Mini-Epaper directory
5. Wait for the installation of third-party dependent libraries to complete
6. Click on the platformio.ini file, and in the platformio column
7. Select the board name you want to use in default_envs and uncomment it.
8. Uncomment one of the lines src_dir = xxxx to make sure only one line works
9. Click the (✔) symbol in the lower left corner to compile
10. Connect the board to the computer USB
11. Click (→) to upload firmware
12. Click (plug symbol) to monitor serial output
13. If it cannot be written, or the USB device keeps flashing, please check the FAQ below

3️⃣ Arduino IDE Quick Start

• It is recommended to use platformio without cumbersome steps

1. Install Arduino IDE
2. Install Arduino ESP32 2.0.5 or above
3. Copy all folders in lib folder to Arduino library folder (e.g. C:\Users\YourName\Documents\Arduino\libraries)
4. Open ArduinoIDE ,Tools , Look at the picture to choose
5. LilyGO-Mini-Epaper -> Any Examples
6. Select Port (Mini-E-Paper-ESP32 PICO requires an external U2T to discover the port)
7. Click upload , Wait for compilation and writing to complete
8. If it cannot be written, or the USB device keeps flashing, please check the FAQ below

6️⃣ FAQ

1. Mini-E-Paper-S3 uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on.
2. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
   1. Connect the board via the USB cable (Mini-E-Paper-ESP32 PICO requires an external U2T to discover the port)
   2. Press and hold the BOOT button , While still pressing the BOOT button, press RST
   3. Release the RST
   4. Release the BOOT button
   5. Upload sketch
3. If the above is invalid, burn the binary file to check whether the hardware is normal