-
Notifications
You must be signed in to change notification settings - Fork 0
Printing parameters
Matteo De Carlo edited this page Dec 6, 2016
·
1 revision
- infill % = 100
- layer height 0.27mm
- number of shells 2
- feedrate 30mm/s
- travel feedrate 30mm/s
- print temperature 235°.
You are free to play with these settings, but remember that a feedrate faster than 30mm/s resulted in the plastic not being correctly fed into the nozzle and the 3d printer didn't print some lines during the process. This defect was cumulative, the second print consecutive was showing many more "missing lines".